TeleFlow Step 0399
From TeleFlow
Set HW Parameter
Sets a value to a particular hardware parameter or setting.
It is advised that hardware settings only be changed by advanced users. Consult the documentation appropriate for your hardware for more information on the hardware parameters.
Contents |
Properties
Name of hardware setting: Supply the name of the hardware setting or parameter you wish to change. Some examples follow.
On NMS hardware, SR barge-in sensitivity can be adjusted with the following hardware settings:
- Evad.Snr - signal to noise ratio (5 to 30 dB)
- Evad.Min_noise - minimum noise floor (-100 to -40 dB)
- Evad.Max_noise - maximum noise floor (-65 to -25 dB)
- Evad.Signal_attack - signal attack time constant (10 to 200 ms)
By default, the SR barge-in sensitivity is set to optimal values.
These should only be adjusted if you are experiencing problems with barge-in.
Value: The value you wish to assign to the hardware parameter or setting. In nearly all cases, this value must be an integer (or evaluate to an integer if you supply a TeleFlow variable).
Action Steps
Fail: The parameter or setting could not be set to the value specified.
Supported Telephony Hardware Platforms
AudioCodes (Ai-Logix)
NMS Communications
Related Steps
