TeleFlow Step 0011
From TeleFlow
Wikilib (Talk | contribs)
(New page: Image:Iv_011.gif <strong><big>Pick Up Step</big></strong><br> Takes the telephone port off-hook, or otherwise answers an in-bound call that was not answered because the preceding [[Tel...)
Next diff →
Revision as of 02:42, 16 May 2008
Pick Up Step
Takes the telephone port off-hook, or otherwise answers an in-bound call that was not answered because the preceding Wait for Call step was set to "Do not pickup after rings".
Contents |
Properties
None. (affects the current port automatically)
Supported Telephony Hardware Platforms
AudioCodes (Ai-Logix)
Dialogic
NMS Communications
Special Hardware Considerations
On analog circuits, you can use the Pick Up step to take the phone off-hook. Digital circuits typically require that a call is offered by the network before the port/channel can be taken off-hook.
Not picking up the phone when a call is offered to the Image:IV 010.gif Wait for Call step, and subsequently using Pick Up step, or 
Hang Up step is only fully supported on digital telephone circuits. This allows the application to detect an incoming call, check if the number dialed to reach the system equates to a particular service offered on the system, and either route the caller to the appropriate service, or hang up to reject the call.
Related Steps
Image:IV 010.gif Wait for Call
Hang Up
